EcoBOS grinder for mass production (coil-to-coil)

Name Value
Type EcoBOS
Diameter range 0,2 - 2,1mm (facet grind)
Length range 14 - 95mm
Tilt angle (alpha) 7,5° to 40°
Rotation angle (gamma) 70° to 150° (travel ±2,5mm)
Cut (grind) types front bevel // grinding with tape
Effective width of grinding jig 385mm
Grinding wheel ⊘ 455 x 80mm
Productivity / Output 30.000 pcs/h (cannula ⊘ 0,7 mm)
Available accessories taping equipment PAZA, detaping equipment DETAP

Attachments

Description

The EcoBOS grinder is designed for point grinding of cannulas and lancets in mass production. On a preparation workplace, the blanks are taped on two adhesive tapes and wind up on a coil magazine. After grinding they are coiled up on a second coil again.

In two steps, this equipment allows even for grinding of both sides (ends) of tubes. The grinder can further be enhanced with a blasting equipment for deburring of the point with glass beads. All set up can be done directly on the equipment or remotely via a smart PLC. One operator can operate usually two or even more equipments, depending on the ground product.

chevron-left-circlechevron-right-circle